The money saving steps to installing a programmable thermostat - WDRB 41 Louisville News

The money saving steps to installing a programmable thermostat

Posted: Updated:

This winter's bitter cold has hit home owners hard with sky-high heating bills. The Home Depot's Scott Kreuger and Joe Autry say the best way to save money on your gas and electric bill is to install a programmable thermostat.

Installing a Thermostat

Few hour-long home improvement projects pay yearly cost-savings dividends like replacing your old thermostat with a new programmable - or "automatic setback" - model. When used properly (and depending on the severity of the winters in your area), you could realize a savings of up to $180 on your yearly energy bills.

Programmable thermostats make the best economic sense for every home. However, the steps below can also be followed for installing a manual thermostat.

Quick tip: When shopping for your new thermostat, check the thermostat package to ensure it is compatible with your home's system.

Remove Coverplate

1. Turn off the power to your heating and air-conditioning system at the main service panel.

2. Remove the old thermostat cover plate with a screwdriver.

Remove Old Thermostat

1. Unscrew the thermostat mounting screws and remove the thermostat body.

2. Label the low-voltage wires to identify their screw-terminal locations using masking tape and then disconnect the wires.

3. Remove the thermostat base by loosening the mounting screws. Tape the wires to the wall to prevent them from slipping into the wall cavity.

Install New Thermostat

1. Thread the low-voltage wires through the base of the new thermostat and mount the thermostat base on the wall using the screws included with the thermostat.

2. Connect the low-voltage wires to the appropriate screw terminals on the thermostat base following the installation diagram in the new thermostat's owner's manual.

Optional: Locate the low-voltage transformer that powers the thermostat. The transformer is usually located near the heating and air-conditioning system or inside of a furnace access panel. Tighten any loose wire connections and make sure the wires and sheathing are in good condition.

3. Install the battery or batteries in the thermostat body (if applicable), and attach the body to the thermostat base.

4. Restore power to your heating/cooling system, then program the thermostat according to the manufacturer's instructions.

If you want a step by step guide from The Home Depot, CLICK HERE.

 

 

 

 

Powered by WorldNow
All content © Copyright 2000 - 2014 WorldNow and WDRB. All Rights Reserved. For more information on this site, please read our Privacy Policy and Terms of Service.